What is the difference between CP2615-EK and CP2615-EK2 ? There seems to be another header in EK2 but are there any other differences? Does EK2 come with A02 by any chance?
Also, what is the difference between CP2615-A01 and CP2615-A02 ? I know the firmware is different but what is different about the firmware? Do they accept difference I2C strings?
The BOM show the part on EK2 is A02 version. You could get the BOM through Simplicity Studio.
Maybe the datasheet/errata helps to understand the difference between the version:
I am having trouble getting the schematics through the Simplicity Studio.
Can you provide me with the schematics for the EK2?
Recommend updating your Simplicity Studio regularly to take full advantage of our software, and documentation, this can be done by pressing the "Update Software" button on the Launcher perspective of Simplicity Studio.
The schematic can be found in the Launcher perspective, see the screenshot below, I also enclosed the schematic here for your convenience.
I am designing a custom board. The EK2 board was CFGMODE#, RESET, SCL & SDA as J15, J16, J13 & J14. These are not on the included schematic and the square pads are undefined.
A programming header will need a ground return. I think this is why you are getting questions. The schematic doesn't match the PCB.
I just want to define a reasonable programming header. I don't have the EK2 board yet to ring it out.
Nevermind, my bad..... I missed that J13-J16 are in the programming section of the schematic and that the J3 cross connections are shorted by 0R0 resistors.