i can't understand how the i2c work with this module.
As the Guide said i've programmed the device with the Xpress Configuration tool. I kept the same Adress 0xE0.
In my program i wait for the INT pin to be low then i start a communication.
Here i've some questions for you...
1) i need to send just 0xE0 as adress or i need to shift and add 1 on the LSB or i need to add just 1 (0xE1)?
2) what is the indicate frequency to operate
3)if the Device send me the ACK after i send the adress will it send me the other 3 byte as well or i need to do something?
I'm sorry for my english and for my question, that are probably stupid.
Thank you for the help
1) Consider what happens when you shift 0xE0 one bit to the left and then answer your own question.
i know what happen if i shift 0xE0 by one but since it don't work i think was important be secure that the adress was correct. Thank you for the helpfull comment