Does Thunderbird React only support 'out' in debugger mode?
i mean selecting debug mode.
so i can connect 'OUT' mode but not 'MCU' mode
I cannot find adapter configuration tab to set the debug mode to out. Could you please check what's wrong with it?
What board you are using as the external debugger?
You could see the setup in page 37 of this document.
Yes, I followed the instruction. I am using the main board of SLWSTK6222A (EZR32WG 915MHz Starter Kit), the adapter board SLSDA001A and the thunder board. But in the instruction, the dialog has three tabs while the dialog in my Simplicity Studio v4, there is just 2 tabs
what is in the instruction:
What I saw in the IDE
It looks like your board was not correctly detected.
Maybe you could try the simplicity commander to confirm it works or not.