How to read flash data from Gecko and Wireless Gecko and store it to file?
This can be done by the command line of Simplicity Commander. The following commands read the flash contents of the specified range and store it in the specified filename. The file format will be auto-detected based on file extension (.bin, .hex, or .s37).
Command Line Usage:
> commander readmem –-range <startaddress>:<endaddress> --outfile <filename>
Command Line Input Example:
> commander readmem –-range 0x0:0x1000 --outfile flashmem.bin
This reads the flash contents from 0x0 to 0x1000 and store it to a binary file (e.g. flashmem.bin).
The address range is non-inclusive, meaning that all bytes from 0x0 up to and including 0xFFF are read out.