Thunderboard Sense with Raspberry Pi and Python
Hi Mr. DDB,
you did a gat job in publishing this code.
I'm trying to interface the Thunderboard Sense board using Node.js with the final target to deliver a nodered node for it, based on NOBLE for Bluetooth 4.0 interface.
I've been partially sucessfull at the moment in reading some environmnet data.
I'd like to be able to drive GPIO signals, so to be able to drive relays (or somthing else) directrly soldered to the board.
I cannot find any hint about which UUIS Services and Characteristics that should be used in order to achieve this.
I've done no changes to the Sense factory firmware.
Sure you have far btter experience then me ... so I'd appreciate a suggestion.
Thanks very much.
Oct 28 2017, 4:28 PM
IoT demo using Thunderboard
Is the sensors starting the advertise without any setup needed ?
Had you to modify the factory set firmware ?
Thanks, nice day
Oct 28 2017, 4:27 PM