Alternative way to start OTA DFU?
at last, I'm back again on this project - i had to manage many more urgent issues first... - so, i added the capacitor between
I have no a clear idea of what happens when gecko_cmd_system_reset(2) is called - I mean, I don't know what function or handler in the bootloader will be executed afterwards. Do you know where in the bootloader I should drive that GPIO?
Feb 21 2020, 9:39 AM
Alternative way to start OTA DFU? on
I'm working on a wearable device equipped with a EFR32MG12 and I'm using OTA DFU to upgrade the firmware. The board
So, to upgrade the application, I first generate the application.gbl then I load it into my smartphone and start the OTA
The upgrade terminates successfully ONLY IF I KEEP THE PUSHBUTTON PRESSED until the end of transfer. Otherwise
To call the appLoader, I currently use the following code:
/* Check if need to boot to OTA DFU mode */
/* Enter to OTA DFU mode */
How could make my application jump in a polite way directly into appLoader code without performing a reset?
ps. i'm using gecko sdk suite 2.5
May 09 2019, 8:28 AM