After Vrapper is installed, the editor will recognize Vim keystrokes (Vrapper can be toggled from the Edit menu). Vrapper will only interpret keystrokes if Eclipse does not use them. Therefore, any keystrokes you want to use will have to be unbound from the Eclipse editor. To do this go to Window->Preferences->General->Keys.
The following steps should be followed to open a GIT repository within Simplicity Studio V3:
1. Install Studio V3
2. Within Simplicity Studio, go to Settings:
3. You will need the following additional update sites in order for Simplicity Studio to successfully install EGit, so in your Settings/Preferences >> Install/Update >> Available Update Sites, add the following:
How do I add a register to the Expressions view in Studio?
There are two main methods to add a register to the "Expressions" view. Drag and drop a register from the "Registers" view into the "Expressions" view, or manually type the group name and register name.
Drag and Drop Registers
In order to drag and drop registers from the "Registers" view to the "Expressions" view, you must first split the register view so that both are visible at the same time. Then perform the following steps:
Expand the registers view and find the desired register you wish to watch
Drag the register or register group to a blank line in the "Expressions" view
Now Studio will display the value of the specified register
Manually Add Register Watch Expression
Alternatively, a register group or register may be added using the GRP() and REG() macros.
To add the entire GPIO group to the "Expressions" view, add the following expression: GRP(GPIO)
To add the PE_DOUT register to the "Expressions" view, add the following expression: