This is related to support ticket 00218574.
I'll also post here on the forum publicly for others too see:
I've noticed, and am slightly confused in the register values shown in the manual when compared to what clockbuilder shows. Which one is the canonical source?
I have a SI5340-D-EB and I wish to manipulate R0_REG: In ClockBuilder (Version 2.40) it says R0_REG is 0x0250[23:0].
However in the Si5341-40-D-RM reference manual from: https://www.silabs.com/documents/public/reference-manuals/Si5341-40-D-RM.pdf, It says R0_REG starts at 0x024A and ends at 0x024C (page 74, table 15.64). So which one is correct? And are there any more incongruencies?
I want to apologize for this confusion and thank you for bringing it to our attention. We will fix these issues in out next revision of the documents.
Meanwhile, I would recommend you to follow what Clock Builder Pro suggests. It is very reliable.