I am using a BGX13P as a master connected to PC to read data stream from another BGX13P module. When I connect to the slave (scan and con commands), data stream come through perfectly. But when I send a break sequence ($$$) on master and then switch back to stream mode (str command), data is corrupted! What can be wrong here? Commands on master are:
scan--> con 1 --> [ Good data stream here] --> $$$ ---> str --> [corrupted data here]
On slave data is always provided continuously on uart port at 115200 bps.
(a capture image attached)
Thanks in advance,
Are you using the latest firmware v1.2.2376.1 (use the command ver to get the firmware version information) for the test ? And can you reproduce the issue with BGX+Phone combination ?