I am running into trouble while trying to add the NCP serial interface to a DMP application.
I started off with the SOC - Empty - RAIL - DMP example.
I tried adding the the NCP interface (BGApi?) on USART2 to the example.
I ran into problems due to the ncp_gecko.h and rtos_gecko.h overlapping.
I managed to somewhat manage to work around that, but it does not work as expected.
The serial communication is working as such, but I neither get the boot event,
nor the correct responses when running commands.
When sending the system_get_bt_address command (0x20 0x00 0x01 0x03) using HTerm,
for example get the response 0x20 0x02 0x01 0x03 0x83 0x01 instead of the expected response.
I was trying to merge the ncp-empty-target and DMP examples in order to control the Bluetooth from a host IPC.
Is there an easier solution on how to correctly add the NCP functionality to the SOC - Empty - RAIL - DMP example?
We don't have a DMP NCP solution nor any guidance on how to do this.
Dear Yves Riehle,
Please could you let me know if you succeed with that NCP application version using DMP?
Thank you and best regards,