I performed all the necessary connections to connect the BLE121LR module, however I can not find it to pair with your phone. Can someone help me?
The connections I made were:
3V3 - AVDD
3V3 - VDD
GND - All GND
RESET - NC
Module is consuming + or - 8 mV.
Are you running one of the SDK's BGScript examples?
I'm not using any software, just did the power connections to run the module.
It does not come from the factory no settings where I put energy into it and it works?
No, these are the factory settings. It essentially comes with BGAPI access via UART so unless you hook it up to a host (microcontroller, PC) and send a couple commands it will just go to PM3.