Is there an example application for measuring throughput on BLE modules?
May I know the throughput of BGM12x? And with BT SW2.0? And also the throughput of Blue Gecko SoC. Witl the SoC get SW updated as well? Thanks.
Could you provide us the example BGScript project to find out how to achieve the max speed of 60 Kbit/sec? I get only 3.4 Kbit/sec then I transmit data between BLE112 and BLE121... Connection interval is minimum 6*1.25 ms = 7.5 ms and <throughput optimize="performance" />. GATT Master reads data using attclient_read_by_handle command and gets attclient_attribute_value event in which it writes data using attclient_attribute_write command and gets attclient_procedure_completed event in which it reads again and so on. No indications. No notifications. I would like to know what the mistake is and how to increase the throughput. Thanks!
Is there any updated version of this document ? I mean how to maximise the throughput using BLE5.0, with the data rate increased to 2Mbps.
I need to maximize the throughput keeping BLE device (EFR32MG21xx) on one end and Android App at the other end.
Thanks & Best Regards,