Does the Mighty Gecko (EFR32MG1P233F256GM48) running the Connect stack support frequency hopping? If yes, is there an example application?
I have the Mighty Gecko Development kit plus three of the above modules (BRD4150B). I tried the sink/sensor application and saw no frequency hopping. I tried both "US/FCC 902MHz-928MHz" and "DSSS 100Kbps" configurations.
This is under development, if everything goes well, we will release it in the end of this year.
@andrasbiro so the Mighty Gecko will support frequency hopping at the end of 2016?
Because I'm about to start a project that absolutely needs frequency hopping and this would be really helpful!
In connect, yes. A decision was made that RAIL shouldn't support frequency hopping, it should be in an upper layer (but it's certainly possible from the application).