I'm realatively new to Embedded world, but as we want to move our design from development board onto a prototype PCB, I'm wondering which pins I should pull out on the programming header. Actually I'm really confused about pin location, as in the datasheet is described, each pin can have multiple functionality, but what is a deafult one, from the factory? Is is LOCATION 0 ?
And please correct me if I'm wrong, while we have pins on the header, we can connect something like ARM Flasher from Segger, and download the .hex generated in simplicity studio, right?
For the debug/programming the device, The SWCLK and SWDIO was only avaIiable on PF0 and PF1.
You could get the information in the datasheet (page 136).
the reference manual and an958 may also help.