We use WF111 module on our custom board running linux 126.96.36.199. We found that we have not the same performance as the module is configured in AP mode or Station mode.
In AP mode, the data rate is very low (barely 2Mbps), while in Station mode, it can reach 8 Mbps. Why this difference? An explanation?
The hardware design has been validated as recommended by Bluegiga. So what can be cause this problem? The AP mode configuration? Is there an optimal configuration (AP mode config, TCP stack config, kernel config) for a good performance?
We need to have more data rate, because it is a very important part of our project. Can you help us to solve this issue?
Thank you in advance.
You also created a support request with the same topic, do you prefer having it handled here?
Thank you for your response.
We just need help. Therefore, all services (official support and community) are asked to find a solution.
We think, you can handle here.