How to setup long range ? I search the files and cannot find out .Is there any file for me ?
For end devices, you should set APP_FREQ to REGION_US_LR_END_DEVICE in config_app.h.
Ensure Z-Wave controller is running a SerialAPI Controller binary supporting US_LR region, e.g.
ZW_SerialAPI_Controller_7.15.2_214_EFR32ZG14_REGION_US_LR.hex for ZG14 based controller.
And, the RF Region of PC Controller (v5.50) is set to US_LR as well for long range testing.
Note: The classic UZB3-S Zniffer stick does not support Z-Wave Long Range, you will need to flash a Znifer PTI firmware (e.g. ZW_ZnifferPTI_7.15.2_214_ZGM130S_REGION_US_LR.hex available in Z-Wave SDK 7.15.x) into a ZGM130S WSTK, and connect it to Zniffer PC application via Ethernet interface on WSTK. More information about the PTI Zniffer IP setup, please see INS10249 Zniffer User Guide, section 3.4.2.
Thank you for the reply .
Do you mean using development board to program Zniffer software ?