Do I need to calibrate the crystal during production?
The requirements for calibration are different depending on the chip:
An overview of the required calibration is further described in document "INS14487 Z-Wave Z-Wave 700 Integration Guide".
How do I change the region on Z-Wave 700 Controller devices?
You can change the region in 2 different ways:
Using the PC Controller
The PC Controller can change region in the ‘Transmit Settings’ menu.
You must use PC Controller 5.38 or newer.
The region can then be changed:
Using the Z/IP Gateway
The region can be changed in the configuration file of Z/IP Gateway by changing a setting in the configuration file:
For valid values, refer to the documentation linked below.
The Z/IP Gateway documentation can be found in Doxygen. The default location is: