In the "MGM210P Mighty Gecko Module Data Sheet", we can read "MGM210P modules are pre-programmed with UART XMODEM bootloader".
Does-it mean that if we would like to load an application in a new module, we don't need to use a programmer with the Mini Simplicity Debug Connector? This can be directly done without a programmer using the pre-programmed bootloader and using the module UART?
Ok, this is a good news!
Do you in which documentation we can find the parameters of the pre-programmed bootloader?
Like the baud rate, the USART used (I guess it's the USART0 with no RTS/CTS at 115200 bps 8N1) and how to trigger the bootloader (if we need to set a GPIO pin during reset or if we can enter the bootloader using the UART).