I'm trying to test the Z3Light and Z3Switch for EFR32MG starter Kit.
I want the coordinator and the end device to form and join a network using UART communication instead of Buttons.
I want to configure UART0 and add its initialization to void emberAfMainInitCallback(void) function. Then, when a send commands from an external Host, the coordinator can form a network for example.
In Simplicity ->HAL, we can't disable the field Application serial port, to disable the UART.
I have noticed also that in the void emberAfMainInit(void) function, we have emberSerialInit(APP_SERIAL, BAUD_RATE, PARITY_NONE, 1); that uses the UART0, i don't want any debug print like emberAfCorePrintln("Reset info: 0x%x (%p)",).
Can you please help to achieve this ? Wich plugin to check, uncheck ? Should i add some Custom Events ?
Thanks for your help,
Can you use the CLI command to form/join the network? Per my understanding, you want to setup communication on the physics UART to connect another Host, am i right? Please clear your question firstly.
How did you connect the Kit to your host? You can use the EXP UART PIN on the WSTK. We have a KBA, please review it first. And please note that you need choose the Virtual UART(port0) as Application serial port in "HAL configuration" in your project *.isc file, so that the UART0 will not be used by serial debugging.