I want to buy dev board from Olimex: EM-32G210F128-H
I have one board from STM, STM32L-DISCOVERY whic have on board
ST-Link/V2 for programming and debugging in SWD mode.
Can I use this programmer for programming Olimex EM-32G210F128-H board?
what does that have to do in a Silicon Labs forum?
This Olimex board is based on EFM32G210F128.
But I don't have money for another programmer/debugger
so my question is, can I use this programmer/debugger from
STM board which supports SWD?
The olimax docs are up to there normal very low standard! So I dont know, but it's unlikely, having said that, give it a go.
You would have been better spending slightly more and getting a STK (starter kit) from here. All the EFM STK's can program any of the EFM chip's, even ones on boards you make yourself and kits like olimax.
I have a feeling the ST board wont work, but nothing to loose by trying. The REAL GECKO boards are much better, I have some Olimax stuff and I am not impressed with it
May be it is possible to use your ST-Link/V2 with your Olimex EM-32G210F128-H Board over Openocd:
I tested OpenOCD with the EM-32G880F128-STK Board and STM32F4Discovery Board and I was able to reset and halt the device and read out some registers.
I collect my results and information here:
Maybe someone have an idea how to flash with OpenOCD, at the moment I'm trying to do this...
I'm now able to flash an EFM32 uC on the EM-32G880F128-STK Board with the ST-LINK/V2 on the STM32F4Discovery Board over OpenOCD.
I have no EM-32G210F128-H Board at the moment, but the bin file here
should work, I tested It last year on the olimex board.