The Gecko Wonder Ref Manual says the TIMER1_CC1 should be PD7 or Expansion Header Pin 17.
I cannot get this Pin to Work for the Timer1 CC1. I Linked PD7 to a Simple LED Light to Turn on and Off. It works Fine for that.
The "Simplicity Studio's" Configurator shows TIMER1_CC1 to be PE11. There is no Expansion Pin for PE11.
Does anyone know the Correct Expansion Header Pin or How to Route it to an Expansion Pin?
I changed the TIMER1 ROUTE Location to 4 (As Shown in Data Sheet) and it Worked as Expected!
I had been reading the User Manual Page 17. It did not Explain that you Had To Change ROUTE LOCATION!
Page 550 of the Reference Manual showed 6 Options for I/O Routing (LOC0-LOC5). It does not give Any Pin Numbers.
I had an Experimental Program working Fine using HYPERCLK as Input. I was Going Crazy trying to get it to work after changing to CC1 Input. ( It's been 30 Years since I got a BSEE and started working in Oil Field)