I'm using WDS 220.127.116.11 to configure Si4460 rev. C2. I don't understand PREAMBLE_CONFIG register (group id = 0x20, index = 0x04). With DSA enable/disable checkbox in "RF parameters" tab UNCHECKED, I expected that bit 6 of PREAMBLE_CONFIG register will be 0 (STANDARD_PREAM selection). Instead header file has bit 6 setted to 1 (DSA_ONLY selection).
Is WDS wrong? And if I want to use STANDARD PREAMBLE DETECTION how I will have to configure PREAMBLE_CONFIG register?
Note: In WDS GUI there's a wrong help popup beside DSA enable checkbox where is written the folllowing message: "Tamas Nagy did not do his job".
Which WDS project are you seeing this at?
For an example of standard preamble detection use project "Custom packet RX" with "Preamble pattern" entry of "Std. 1010 pattern (>40bit)"
I'm using Empty Framework selection. See attached files.