I am new to zigbee of silabs. I can create a blank_znet project and it can output message of"RESET INFO...." from usart0, but when I create a Z3light or Z3lightGPcomboSOc by the similar configuration, nothing I get from usart0, and the RX TX pins always keep low, it seems the program not run at all.
is that the bootloader problem? I ve try several kinds of bootloader but still not work.
.isc file attached.
HI sam luo, the isc file you attached can't be opened. Can you check?
Thanks all of you.
1.customized, similar to brd4173A , blank_znet can run...
2. Just download the file and can open in my computer.version 126.96.36.199
Hi sam luo,
I can import your .sls file, but can't open the isc file. In your hardware configurator, please don't use TIMER0 as it is already used by the stack.
And also you need to create a bootloader project and flash it into your board.
bootloader-storage-spiflash-single-combined.s37 is from simplicity studio.
Why have you disabled the DCDC converter?
Do you have any buttons or leds defined on your custom board?
Here is firmware to test on your board - no leds or buttons. You can program using Commander.