I am new to zigbee of silabs. I can create a blank_znet project and it can output message of"RESET INFO...." from usart0, but when I create a Z3light or Z3lightGPcomboSOc by the similar configuration, nothing I get from usart0, and the RX TX pins always keep low, it seems the program not run at all.
is that the bootloader problem? I ve try several kinds of bootloader but still not work.
.isc file attached.
I program your s37 and hex. but still no print. did you config PA0 as TX @115200bps?
Z3LightSoc_2.sls is working. when I enable DCDC. it is disable in default.
I see print out.
Thanks all of you.