Ultra-Low Power Wireless System on a Chip

• Wi-Fi 6 Single band 2.4 GHz and Bluetooth Low Energy 5.4 wireless radio
• ARM® Cortex®-M4F Application MCU up to 180 MHz
• Integrated baseband processor, RF transceiver, high-power amplifier, balun and T/R switch
• Embedded SRAM up to 672 KB
• Embedded Flash up to 8 MB and supports opt external Flash up to 16 MB
  
• Embedded PSRAM up to 8 MB and supports Opt external PSRAM up to 16 MB
  
• Integrated Wi-Fi stack, TCP/IP stack, Bluetooth stack supporting wireless coexistence and Matter

Wi-Fi 6

• Compliant to to 2.4 GHz, single-spatial stream IEEE 802.11 b/g/n/ax
• Supports 802.11ax 20 MHz features such as OFDMA, MU-MIMO, and Target Wake Time (TWT)
• Transmit power up to +20 dBm with integrated PA
• Receive sensitivity as low as -97.5 dBm
• Data Rates: up to 86 Mbps (802.11ax MCS0 to MCS7)
• Operating frequency range: 2412 MHz - 2484 MHz

Bluetooth Low Energy 5.4

• Transmit power up to +19.5 dBm with integrated PA
• Receive sensitivity: LE: -95 dBm, LR 125 Kbps: -106 dBm
• Operating frequency range: 2402 MHz - 2480 MHz
• Bluetooth Low Energy 1 Mbps, 2 Mbps and Long-Range modes (125 kbps, 500 kbps)

Microcontroller Subsystem

• ARM® Cortex®-M4F core with up to 180 MHz
• Integrated FPU, MPU, and NVIC
• In-System Programming (ISP) and Over-the-Air (OTA) wireless firmware update
• Power-On Reset (POR), Brown/Black-out and Black-out Detection
• Rich set of Analog and Digital Peripherals
• Digital Peripherals - SDIO, 1x USART, 2x UART, 4x SPI, 3x I2C, 2x I2S, SIO, PWM, QEI
• Timers: 4x 16/32-bit, 1x 24-bit, WDT, RTC
• Up to 45 GPIOs (GPIO Multiplexer)
• Analog Peripherals - 12-bit 16-ch, 5 Msps ADC, 10-bit DAC
• 3x Op-amps 2x Comparators, IR detector and Temp Sensor, 8 capacitive touch sensor inputs

High Level of Security

• QSPI Encrypted XIP from Flash (w/ AES-XTS)
• Secure Zone
• TRNG, Root of trust (PUF)
• Secure Boot & OTA
• Advanced Cryptographic Accelerators
• Secure Key Storage, Secure Debug, Anti Rollback and Secure Attestation

Ultra-Low System Power Consumption

• Wi-Fi Standby Associated mode current: 55 μA @ 1-second interval
• Deep sleep current ~ 2.5 μA, Sleep/Standby current (RAM retention)  ~ 10 μA
• Low MCU Sub-system active current: 32 μA/MHz in LP mode

Matter

• Matter over Wi-Fi with Bluetooth LE commissioning

Software and Protocol Support

• Integrated Wi-Fi stack, TCP/IP stack, Bluetooth stack supporting wireless coexistence
• Support for Embedded Client mode, Access Point mode (up to 8 clients), Concurrent Wi-Fi and Bluetooth LE mode
• Supports advanced Wi-Fi and Networking security features: WPA, WPA2 (Personal/Enterprise), WPA3 (Personal)
• Integrated TCP/IP stack supports HTTP/HTTPS, DHCP, SSL/TLS1.3, MQTT
• Wireless firmware upgrade and provisioning
• Supports both hosted (Radio Co-Processor (RCP), and Network Co-processor (NCP) modes and host-less (SoC) modes

Operating Conditions

• Wide operating supply range: 1.75 V to 3.63 V
• Operating temperature: -40°C to +85/105°C  

Package Size

• QMS: 7.00 mm x 7.00 mm x 0.85 mm

Development Environment

• Simplicity Studio v5, GitHub